Foreword
Introduction
This manual provides instructions for starting and configuring the barcode
scanner, as well as maintenance and customer support information.
Some content about the above models are not supported in this manual:
1.
Chapter 2 Interface Type
2.
Chapter 3 input and output settings :Good Read Delay
3.
Chapter 5 Data Formatting
4.
Chapter 6 Symbologies code 39- Full ASCII,UPC-E1
The barcode scanners are factory configured for common terminal and
communication settings. If you need to change it, you can scan the
barcode configuration code in this manual to modify it.
An asterisk (*) indicates the default configuration.
To Next Page
