10 © Prowise 2018
• Unplug the lift during thunderstorms. We advise to use an overvoltage protection
device to protect the lift against damage due to voltage peaks or a lightning
strike to the electrical mains supply.
2.5. Ergonomics
Always adjust the screen to the correct height before use. Avoid standing in a
stooped or bent posture and ensure that the ends of the screen are located within
arm’s reach.
In the optimal position of the screen, you can touch both the top and bottom of the
screen without needing to stoop or reach far up. By positioning the screen properly,
you can avoid physical problems that could result from an incorrect work posture.
Only move the lift with at least two persons and never carry the lift up a staircase.
Use a ramp to prevent physical complaints and injuries.
2.6. Connecting
Follow the instructions below to connect the lift safely:
WARNING!
Do not use damaged power cables or plugs. Only replace defective power
cables with original parts. Never repair damaged cables and plugs yourself.
• The lift must be placed close to an electrical outlet and the electrical outlet must
be easy to reach.
• Disconnect the power from the the lift by switching off the power switch and
removing the power cable plug from the electrical outlet.
• Only plug the power cable into grounded electrical outlets with AC 100-240V
~50/60Hz. If you are not sure about the power supply at the installation location,
consult your energy company.
• Only use the power cable supplied.
• We advise you to use an overvoltage protection device to protect the
touchscreen against damage due to voltage peaks or a lightning strike to the
electrical mains supply.
To Next Page
Loading...
