Proxim Tsunami Multipoint MP-820-BSU-100 User Manual

8000 Series - Hardware Overview and Installation
Tsunami
®
800 and 8000 Series - Hardware Installation Guide 71
Antenna Alignment Commands
To enable the antenna alignment display from the CLI prompt, enter the following commands:
 ² ² ³ ´ µ ² ¶ · ´ · ¸ ¹ ² ·
: Enables display of the local signal, noise and SNR.
 ² ² ³ ´ µ ² ¶ · ´ º ´ » ¸ ¼ ´
: Enables display of the remote signal, noise and SNR.
 ² ² ³ ´ µ ² ¶ · ´
: Enables display of local and remote signal, noise and SNR.
: Use a flat blade screw driver to disconnect and pull out the Serial cable from the enclosure after the antenna
alignment is done. After withdrawing the cables, seal the serial port carefully to avoid water seepage.

Proxim Tsunami Multipoint MP-820-BSU-100 Specifications

General

Brand	Proxim
Model	Tsunami Multipoint MP-820-BSU-100
Category	Wireless Access Point
Language	English