PROXXON – MICROMOT-
Orbital Sander SL 12/E
Dear customer,
Please read the enclosed safety regulations and
operating instructions carefully before using the
unit.
Attention!
- Keep the working area clean and tidy.
- Do not use electrical tools in rain, under wet
conditions or in the vicinity of inflammable
liquids or gases.
- Avoid contact with earthed parts such as
pipes, radiators cookers and refridgerators.
- Keep children away from the working area.
- Always wear goggles.
- Wear a breathing mask under dusty working
conditions.
- Store unused tools in a locked room out of
the reach of children.
- Before starting to work check the machine for
any obvious faults, replace damaged parts.
- Do not overload the machine.
- Do not use weak tools for heavy duty work.
- Do not carry the machine by the power cable.
- Protect the power cable against heat and
sharp edges and only have it replaced by a
specialist
- Fasten and clamp the workpiece securely.
- Replace blunt tools.
- Clean the machine thoroughly after use.
- Always disconnect the power cable if the
machine is not in use, when changing tools or
case of repairs.
- Inspect unit for damage before use
replace defective parts.
- Repairs in the electric system should only
be carried out by a specialist.
- Use only accessories and spare parts which
are mentioned in these instructions or recom-
mended by the manufacturer.
- Keep fingers away from rotating and fast-
moving tools (saw blade etc.).
We reserve the right to make further alterations
for the purpose of technical progress.
General view (Fig. 1)
1. Speed control knob
2. Power cable
3. ON/OFF switch
4. Sanding plate
Tool description
The PROXXON – MICROMOT orbital sander SL
12/E is the ideal device for contour sanding,
rough, and fine sanding of surfaces and edges,
resurfacing of primed surfaces and surface
finishes.
Technical data
Length: approx. 160mm
Weight: approx. 400g
Sanding surface: 80 x 58 mm
No. of strokes: 1,000-5,000/min
Voltage: 12-18 Volt
Power rating: 100 watt
Noise emission: ≤ 70 dB(A)
Vibration: ≤ 2.5 m/s
2
Connecting the tool
1. Ensure that the tool is switched off before
connecting to voltage supply unit.
2. Note correct polarity of plug.
Note:
- Only use voltage supply units with sufficient
power rating. We recommend the PROXXON
Voltage Supply Unit NG 2(E) or NG 5(E).
- When using an adjustable voltage supply
unit, set the voltage supply unit to maximum
(max. 18 Volts) and control output at the tool.
- Tool control only functions when using volta-
ge supply units that are not stabilised (all
PROXXON voltage supply units). When using
a stabilised voltage supply unit or a battery,
the tool operates at maximum speed.
- PROXXON voltage supply units switch off
automatically when overloaded. Pull out the
mains plug and allow the voltage control unit
to cool for several minutes.
Important
Only use safety transformers.
- 6 -
GB
To Next Page
Loading...
