EDDYTHERM operating manual
19
Temperature probe
The EDDYTHERM can be operated with automatic temperature detection using two different types of temperature
probes.
Magnetic probe
This temperature probe [ETH 7305] is equipped with a powerful permanent magnet that attaches itself to any
ferromagnetic material. It may be used at temperatures up to 240°C/464°F.
Attaching the magnetic probe
Attach the probe to the side of the workpiece: in roller bearings, it should be applied at the top of the inner ring
(heat rises).
Detaching the magnetic probe
Remove the probe only by pulling on the holder and not on the cable. Wear protective gloves.
The workpiece may be hot.
1
2
3
1
2 3
To Next Page
Loading...