5-21
VIBXPERT 11.2010
Measurement tasks
Creating a Multitask
(in the OMNITREND route editor)
Creating a multi-measurement task for a route / machine template
Multi-measurement tasks for this operating mode are created in the
OMNITREND editor for routes or machine templates. To do this,
activate the 'Multitask' option (see below). OMNITREND then auto-
matically combines the relevant measurement tasks into a single
multi-measurement task.
Note
Breaking down a multi-measurement task
To measure the measurement tasks of a multi-measurement task
individually in the route/machine template, proceed as follows:
• Open the selection list of the measurement tasks (see P. 3-8).
• Highlight the multi-measurement task.
• Press the MENU key and click on 'Break down Multitask' (see
below).
This process is not reversible (see P. 3-10)!
Left:
Breaking down
a multi-measurement task
(Route / Machine template)
Right:
Individual measurement tasks
To Next Page
Loading...
