Need help?Do you have a question about the Prusa Research Original Prusa XL and is the answer not in the manual?
General| Filament diameter | 1.75 mm |
|---|---|
| Nozzle Temperature | Up to 300 °C |
| Heated Bed Temperature | Up to 120 °C |
| Power Panic | Yes |
| Extruder Type | Direct drive |
| Build volume | 360 x 360 x 360 mm |
| Nozzle diameter | 0.4 mm (default) |
| Connectivity | USB, Ethernet, Wi-Fi |
| Supported materials | PLA, PETG, ASA, ABS, PC, HIPS, PVA, PVB |
| Automatic First Layer Calibration | Yes |
| Tool Changer | Up to 5 independent tool heads |
| Bed Leveling | Automatic |
| Power Consumption | Max 500 W |
| Power Input | 110-240 V AC, 50/60 Hz |
To Next Page
