4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com
Getting Started
Getting Started xxi
©2016 PS Audio Inc. All rights reserved.
®
Owner’s Reference DirectStream Junior
the display for 3 seconds to enter the setup scroll to the Version screen.
When a new operating system become available, it may be obtained by ordering
a pre-programmed USB memory stick directly from PS Audio, or downloaded to
your own USB memory stick for free from the PS Audio website. To install, place
the USB stick in the rear of DirectStream Junior. Then, turn o the rear panel
power switch. Wait for 10 seconds, then turn the rear panel main power switch to
the on position, rebooting the instrument. The front panel Ready Light will begin
blinking, signifying the new rmware is being installed.
DO NOT REMOVE THE POWER OR DO ANYTHING WHILE THE UPDATE
PROCESS IS TAKING PLACE. BE PATIENT AND WAIT UNTIL THE LOGO LIGHT
BLINKING IS DONE.
Once the blinking has nished, keep the power to the unit on until it has fully
initialized and is ready for operation again. Remove the USB memory stick.
DirectStream Junior does need some care and is appreciative of being fed proper
AC power. A Power Plant AC regenerator is recommended for this task.
Should minor scratches occur in your top cover, simply purchase any type of high
quality automotive scratch removal polish such as Kit’s Scratch Out or McGuire’s
products. Car nish polish and wax can both be used on this surface for a beautiful
luster.
When new
rmware is
available
To Next Page
Loading...
