®
Owner’s Reference Sprout
4826 Sterling Drive, Boulder, CO 80301 . PH: 720.406.8946 . www.psaudio.com
©2014 PS Audio Inc. All rights reserved.
accept the direct output of your turntable’s phono cartridge.
Analog. Select this input if you have a phone, television, Sonos or
other device with an analog output connected to Sprout’s rear panel
connector labeled “Analog In”.
Digital. Select this input if you have either of the two digital inputs
connected: USB or COAX. We recommend you plug only one of these
two digital inputs in at a time. Should you have both USB and COAX
plugged in at the same time, USB will take precedence over COAX when
the computer it is connected to is on.
The digital inputs can accept sample rates and bit depths up to
192kHz/24 bits.
If you are using USB connected to a computer, it may be necessary for
that computer to have a PS Audio driver installed to connect Sprout. If
you have a Mac it is already installed. If you
are connecting to a Windows computer, you
must install the PS Audio Driver rst. See the
previous input connection instructions in this
manual for details.
Bluetooth. Select this input if you have
connected a mobile device or computer
enabled with Bluetooth to Sprout. Bluetooth
is a wireless method of connecting devices
together. To connect to Sprout from a
Bluetooth enabled device, such as an iPhone
or an Android, go to the mobile devices
settings menu and nd Bluetooth. Make sure
the mobile device’s Bluetooth is active and on.
To Next Page
Loading...
