PTZOptics Move 4K - Page 41

40
™
534 Trestle Place Downingtown, PA, 19335 USA · Tel: +1(484)593-2247 · Email: support@ptzoptics.com
• RTMP(S) Stream 1 & 2 Settings
Ŝ RTMP(S) Stream URL: Dene the RTMP Address of the CDN you wish to stream to.
Ŝ RTMP(S) Stream Key: Dene the stream key of the CDN you wish to stream to.
Ŝ Enable Stream: Toggle the RTMP stream on or o.
• SRT Settings
Ŝ SRT: Toggle the SRT stream on or o.
Ŝ SRT Mode: Dene whether the SRT stream is pulled (Listener) from the camera, or
whether the stream must be pushed (Caller) to a server.
Ŝ SRT Server: Dene the Server IP address. This is only used in Caller mode.
Ŝ SRT Port: The SRT Port is how you reach the SRT video feed of your camera.
Ŝ SRT Encryption: Toggle SRT Encryption on or o.
Ŝ SRT Password: Dene the SRT password when utilizing SRT Encryption
Ŝ SRT Bandwidth Overhead: SRT Bandwidth is a percentage that you assign that
helps determine the total bandwidth that the SRT stream will use up. This
percentage should not exceed 50%, and is set to 25% by default.
Ŝ SRT Variable Latency(ms): Dene the maximum buer size for maintaining SRT
packets from the camera to the destination.
• RTSP Settings
Ŝ RTSP Authentication: Toggle RTSP Authorization on or o.
Ŝ RTSP Port: The RTSP Port is how you reach the RTSP video feed(s) of your camera.
• Multicast Settings
Ŝ Multicast Mode: Toggle Multicast on or o.
WARNING! Only use this setting with a network congured for Multicast.
Ŝ Multicast Address: Dene the Multicast Address. Recommended format:
234.1.2.[camera IP address last octet]
Ŝ Multicast Port HD: The Multicast Port HD is how you reach the HD stream through
RTP Multicast.
Ŝ Multicast Port SD: The Multicast Port SD is how you reach the SD stream through
RTP Multicast.
• ONVIF Settings
Ŝ Enable ONVIF: Toggle ONVIF control on or o.
Ŝ ONVIF Authentication: Toggle ONVIF Authentication on or o.