E)
OPERATING
INSTRUCTION
1. Prop the moped
on
its stand.
2.
Unlock fork.
3. Turn
fuel valve
to
the
ON
position.
4.
Be
sure that
the
engine stop switch
is
in
the
RUN
position.
5.
If
engine
is
cold, depress the choke and depress the primer
button on the carburetor
until fuel drips from carburetor.
CAUTION:
After completing step 5 do not open the throttle
control,
as
this will deactivate the choke. After the engine
has started
and
warming
up
, open throttle gently
to
the full
position briefly. This will disengage choke. Avoid rating
engine.
6. Keep . both hands
on
the handlebar with the weight of the
moped centered
on
the front wheel. Apply the front brake and
fully
depress the starting lever located
on
the left side of the
handlebar.
Pos
ition the pedal approx. parallel
to
the chain
guard.
While holding the starter lever,
push
the pedal
to
start
engine.
7.
Alternate starting method:
The moped may
also
be
started
by
pedalling
as
a bicycle.
When
momentum has been gained, pull the start lever
and
gently open the throttle. Release the start lever after the
engine starts.
To Next Page
Loading...
