Pudu BellaBot Pro - Working Environment

BellaBot Pro Operation Guide
Version V1.0 Operation Guide
6
ines.
 When the robot is in motion, no playing is allowed in front of the robot to avoid
unnecessary harm.
 Do not move or transport the robot while it is working to prevent it from moving
abnormally.
 In case of emergency, stop the robot by pressing the emergency stop button on the
top.
 The robot must not be disassembled or repaired by untrained personnel. In case of
malfunction, contact Shenzhen Pudu Technology Co., Ltd. for technical support in time.
 Observe the maximum weight a person is allowed to lift as required by local laws
and regulations when transporting the robot. Keep the robot upright during transportation.
Never attempt to transport it by lifting the tray or the box.
 Do not spill any liquid into the robot to avoid any damage.
 Although the robot features automatic obstacle avoidance, never block the robot
moving at a high speed to avoid any accidents.
 Please prevent the robot from violent impact or shock to avoid any damage.
 Do not clean the robot with caustic chemicals, cleansers, or detergents. Always
clean the robot by wiping it with a clean and dry cloth.
1.3 Working Environment
 Do not use or charge the robot in a high temperature/pressure environment, areas
with fire or explosion hazard, or other dangerous scenarios to avoid personal injury or
robot damage.
 The robot can only be used in an indoor environment on a flat and smooth surface
with a slope less than 5° and protrusions not more than 1cm(0.39in) high.
 Do not use the robot in a humid environment or on surfaces covered with fluid or
gooey stuff to avoid damage to the robot.
 Do not use the robot in places where the use of wireless devices is explicitly
prohibited, otherwise it may cause interference to other electronic devices or lead to other
dangers.
 The minimum travel width for a single robot is 0.65m(2.13ft). The travel width is
recommended to be greater than 1.6m(5.25ft). when two robots pass head-on. Otherwise,
they should pass through in turn. The width of the standard kitchen entrance should be
greater than 1.2m(3.94ft). Otherwise, it may cause congestion.
 There is a 35cm(13.78in) space between the two robots placed side by side at the
standby point, and a clearance of 15cm(5.91in) from the rear wall and 35cm(13.78in)
from the side wall.