LED SMT Reflow Oven T-980 User Manual
Https://www.te168.com
8
/
11
5. Click the "Time Setting" button to enter the following interface:
By dragging the ruler slider left and right to change the PCB run time, the run speed
of the belt can be changed.
6. Click "Test Data" to enter the following interface:
By clicking the button, you can turn on or turn off a single temperature zone. When
the temperature zone is turned on, the button will display green and the temperature
zone off,button will display red.To end the heating state of the machine, click the
"Finish" button.
6.Special reminder:
① .When welding chip, select appropriate curve according to chip size and welding
process requirements.
②.If the touch screen crashes, the machine will automatically cut off the heating, and
there is no need to worry about the chip burning out of control.
③.The touch screen alarms. The fault is that the single chip computer crashes or the
communication line between the main board and the touch screen is damaged.
④
.When the touch screen has been in the state of over temperature alarm (the display
To Next Page
