Page 7
CHALLENGE VS. SOLUTION
WARNING: Never perform any of the following actions while any part of a person is between the vehicle and the trailer.
1. Once you have the trailer located and are ready to unhitch, block the trailer wheels so it will not roll back or forward.
2. Pull the Latch Handle {B1} towards the rear of the vehicle and rotate either clockwise or counter clockwise into the
slotted opening as you did in the “Hitching” section. The latch pin must be retained in the open position to release the
adapter ball from the tube.
3. Extend the trailer jacks until the ball is fully removed from the Coupler Tube {B} and above the top of the coupler
funnel.
4. After lowering the truck’s tailgate, disconnect the trailer’s electrical cord and break-away switch cable, then pull
forward.
CAUTION: If you nd it necessary to reposition your trailer, you must follow the hitching procedures to ensure the hitch
is latched before moving the trailer.
UNHITCHING
CHALLENGE SOLUTION
Cannot open the Latch Pin. Should only be restricted if trailer is applying pressure to the pin.
Raise trailer jacks to relieve ball pressure against pin.
My King Pin Adapter isn’t tting well over the king
pin.
Paint or “crud” build up on the upper ange of the king pin
(particularly near the junction of the king pin and skid plate),
bent, skewed, or king pins that are too long or too short can
cause a poor t. Contact PullRite’s Customer Service Dept. at
(800) 443-2307 and we’ll give you suggestions on how to correct
it.
Trailer overhang is hitting the truck bed rails when
the trailer and truck are at sharp angles.
Raise or lower the hitch coupler height and/or lower the king pin
box. There should be at least 6” between the top of the bed rails
and bottom of the trailer.
The latch handle mechanism seems too stiff to
operate.
Spray the locking mechanism with WD-40. Work the handle until
it slides freely. If the problem persists, you may need to degrease
and re-lube all working parts.
I need to have a professional evaluate my
SuperLite.
Contact PullRite’s Customer Service Dept. at (800) 443-2307.
Your needs will be assessed and resolved by PullRite or you will
be directed to an authorized PullRite Service Center.
To Next Page
Loading...
