Page Page
1. Intended Use .................................................................3
2. Installation Instructions.................................................3
3. Instructions for Battery Storage ....................................3
4. Instructions for Replacing Batteries ..............................4
5. Instructions for Disposal of the Batteries......................4
6. Product pictures ............................................................5
7. Functional Diagram .......................................................5
8. Environment ..................................................................6
9. Sensor Board .................................................................7
10. Terminals and Wiring ....................................................7
11. Protection Features .......................................................8
12. Approved, Fulfilled or Tested Standards.......................8
13. Regulatory Product Compliance....................................8
14. Physical Dimensions and Weight ..................................9
15. Recommendations for a Long Battery Life..................10
16. Mounting Orientations ................................................11
The information given in this document is correct to the best of our knowledge and experience at the time of publication. If not
expressly agreed otherwise, this information does not represent a warranty in the legal sense of the word. As the state of our
knowledge and experience is constantly changing, the information in this data sheet is subject to revision. We therefore kindly ask you
to always use the latest issue of this document (available under www.pulspower.com).
No part of this document may be reproduced or utilized in any form without our prior permission in writing.
Risk of electrical shock, fire, personal injury or death.
- Turn power off before working on the device. Protect against inadvertent re-powering.
- Do not modify or repair the unit.
- Use caution to prevent any foreign objects from entering the housing.
- Do not use in wet locations or in areas where moisture or condensation can be expected.
- Do not touch during power-on, and immediately after power-off. Hot surfaces may cause burns.