English
17
STOPWATCH
● Restart and stop of the stopwatch can be repeated by pressing button A.
● Measurement and release of split time can be repeated by pressing button B.
SINGLE-TIME ALARM
● The single-time alarm cannot be set for a time more than 12 hours ahead of the current
time. While you keep button B pressed to advance the ALARM hands quickly, they stop
when they indicate the current time and the alarm is disengaged. In that case, release
button B, and then, press and hold the button again to set the ALARM hands to the
desired time.
● While the crown is at the normal position, the ALARM hands indicate the current time
when the alarm is disengaged and the designated alarm time when it is engaged.
● While the stopwatch is measuring, the alarm rings differently than usual. However, this
is not a malfunction.
● While the alarm is ringing, pressing button A or B will only stop the alarm, and no
stopwatch operation can be made.
● To correct the alarm time you have set, follow the procedure described in “ALARM
TIME SETTING”.
To Next Page
Loading...
