Pulsar Accolade XP50 - USB Connection; Connecting Device via USB

WIRELESS REMOTE CONTROL
(bought separately)
21
Wireless remote control (RC) duplicates the
POWER ON function, digital zoom, video
start/stop and menu navigation.
150
149
18
19
20
17
Brief press Enter quick
menu
Turn on
device /
Calibrate
sensor
Controller
(17)
Button
ON (18)
Activate
discrete
zoom
Button
ZOOM (19)
Start video
recording
Button
REC (20)
Long press Enter main
menu
Display Off /
Turn off
device
Activate
function PiP
Switch
between
video/photo
modes
Clockwise
rotation
Increase
parameter,
move upwards
- - -
Counter-
clockwise
rotation
Decrease
parameter,
move
downwards
- - -
TECHNICAL INSPECTION
22
Check:
USB CONNECTION
20
Connect one end of the USB cable (16) to the Micro-USB (15) port of
your device, and the other end to the USB port of your PC/laptop.
Turn the device on with a short press of the ON/OFF (11) button
(device that has been turned off cannot be detected by your
computer).
Your device will be detected by the computer automatically; no drivers
need to be installed.
Two connection modes will appear
on the display:
Memory card (external memory)
and Power.
Select connection mode with UP
and DOWN buttons.
Confirm selection with a short press of the M button.
USB connection
Use as power
Use as memory card
Connection modes:
Memory card (external memory). In this mode the device is
detected by the computer as a flash card. This mode is designed for
work with the files saved in device's memory. The device's functions
are not available in this mode; the device turns off automatically.
If video recording was in progress when connection was made,
recording stops and video is saved.
When USB is disconnected from the device where connection is in
the USB Mass storage device mode, the device remains on the OFF
state. Turn the device on for further operation.
Power.
In this mode PC/laptop is used as an external power supply. The
status bar shows icon . The device continues operating and all
functions are available.
Note: The Battery pack installed in the device is not being charged!
When USB is disconnected from the device when in the Power mode,
the device keeps operating with Battery Pack, if available, and it has
sufficient charge.
External view (there should be no cracks on the housing).
The state of the objective and eyepiece lenses (there should be no
cracks, spot, dust, deposits etc. ).
The state of the Battery Pack (should be charged) and electric
terminals (there should be no oxidation ).
Correct functioning of the controls.