Pulsar Axion 2 LRF XG35 - Page 54

Possible cause
The device is in an area with too many Wi-Fi networks that may be causing signal
interference.
Solution
To ensure a stable Wi-Fi connection, relocate the device to an area with fewer or no
Wi-Fi networks.

Possible cause
The device has a 5 GHz network enabled, but the smartphone only supports 2.4 GHz.
Solution
Switch the device's Wi-Fi bandwidth to 2.4 GHz.

More information on solving problems with connection to Stream Vision 2 by
following thelink.
Wi-Fi signal is missing or interrupted
Possible cause
Smartphone or tablet is out of range of a strong Wi-Fi signal. There are obstacles
between the device and the smartphone or tablet (e.g., concrete walls).
Solution
Relocate smartphone or tablet into the Wi-Fi signal line of sight.

More information on solving problems with connection to Stream Vision 2 by
following thelink.
Rangefinder does not measure distance
Possible cause
There is an object in front of the receiver or emitter lens preventing signal
transmission.
Solution