Pulsar Axion Compact XM30F - Page 12

Battery completely charged . Charging will automatically stop . The battery can be
disconnected from the charger .
* Available separately
 The indicator displays the current level of charge of the battery for 30 seconds when
the APS charger is not plugged in . When the power is connected , the display shows the
current status of the battery constantly , the LEDs additionally flickering to indicate the
battery charging process .
Battery Installation
Attention !  Before installing the battery , make sure that there is an undamaged rubber
insulating ring on the battery . The ring is designed to protect your device from moisture
getting inside . Damage to the device due to a missing ring is not covered by the
warranty . To replace or purchase a ring , contact your  local distributor .
 Insert the battery  10  into the assigned slot on the device ʼ s casing  14 , aligning the
images to form a ‘ dot ʼ on the device   C   and the battery   A  .
 When properly installed , the battery is locked into the slot with a special clip .
 To remove the battery from the device , press the Battery Release button  9 .