Pulsar Axion Compact XM30F - Page 34

 Press the  MENU 3  button briefly to enter the submenu .
 Use the  UP 4/ DOWN 2  buttons to select one of the calibration modes described
below .
 Press the  MENU 3  button briefly to confirm the selection .
M mode  Manual 
Close the lens cover  7 .
Press the  ON / OFF 5  button briefly .
Open the lens cover  7  after the calibration is completed .
SA mode  Semi - Automatic )
The user independently determines the need for calibration ( according to the image
being observed ).
Press the  ON / OFF 5  button briefly to activate calibration .
There is no need to close the lens cover because an internal shutter covers the
microbolometer automatically .
A mode  Automatic )
The device is calibrated autonomously according to firmware algorithms .
There is no need to close the lens cover because an internal shutter covers the
microbolometer automatically .
In this mode , the user can still choose to calibrate the device using the  ON / OFF
5  button if required ( as in the  SA  mode ).
In Automatic calibration mode a countdown timer  will appear instead of the
calibration mode icon 3 seconds before automatic calibration begins .
Notes :
During calibration , the image on the display briefly freezes for up to 1 second .
The selected calibration mode is saved after restarting the device .
General Settings