Pulsar KRYPTON 2 - Page 12

 Move the lever  3 to the open position .
 Install the Battery Pack  4  into the charger .
 Lock the battery  4 by moving the lever to the closed position .
Step 2. С heck the current battery level
Upon installation , a green LED indicator on the charger will start to glow and begin
flashing :
– once if the battery charge ranges from 0% to 50%.
– twice if the battery charge ranges from 51% to 75%.
– three times if the battery charge ranges from 76% to 99%.
When the indicator is continuously green , the battery is fully charged . Disconnect
the charger from the mains and disconnect the battery from the charger .
If the battery charger indicator is constantly red when the battery is inserted , the
charge level is probably below the permissible level ( the battery has been in a
discharged state for a long period of time ). Leave the battery in the charger for a
long period of time ( up to several hours ), then remove and reinsert .
If the indicator begins to flash green , the battery is good .
If it continues to show red , the battery is defective . Do not use this battery !
The LED indicator will display the battery charge status :
LED Indicator Battery Charge Status
Battery is empty
Battery charge level is from 0% to 50%
Battery charge level is from 51% to 75%
Battery charge level is from 76% to 99%
Battery is full