Pulsar KRYPTON 2 - Page 11

 Connect the other end of the USB cable  20  to the Power Adapter  21 by removing
the USB Type - A adapter .
 Plug the Power Adapter  21  into a 100240 V socket .
 Wait until the battery is fully charged ( indication in the status bar : ).
If the device is off , the LED indicator will display the battery charge status :
LED indication Battery status
Battery is charging
Battery is charged
Defective battery .
Do not use the battery !
– The device is switched on
Option 2
Charging
Step 1. Install the battery into the charger