Pulsar KRYPTON 2 - Page 23

1. Align the protrusions on the monocular 23  on the side of its lens with the grooves of
the mount  18  of the attachment .
2. Turn the monocular clockwise to secure it on the attachment . The recommended
position of the clamping screw  24  is at the bottom ( see Figure ).
3. Turn on the attachment by pressing the  ON / OFF 8  button .
4. Adjust the eyepiece diopter ring  25 until the symbols in the display are sharp .
5. Loosen the screw 24  with an Allen key S 3.
6. Align the display to the center of the image in the monocular by tilting the attachment
in the required directions .
7. Lock the monocular in the chosen position by tightening the screw 24  until it stops
( clamping force – 2.5 Nm / 22.13 in - lbs ).
8. To remove the monocular , turn it counterclockwise and disconnect from the
attachment .
Powering on and Image Settings