Pulsar KRYPTON 2 - Page 66

After turning on the device , it takes some time for the sensor temperature to stabilize .
This is normal and is not a defect .
Image is too dark
Possible cause
Brightness or contrast level is too low .
Solution
Adjust the brightness or contrast in the  Quick Menu .
Color bars appear on the display or the
image disappears
Possible cause
The device was exposed to static charges during operation .
Solution
When the exposure to static charges is over , the device may either reboot automatically
or require to be switched off and on again .
The image of the object being observed is
missing
Possible cause