Pulsar KRYPTON 2 - Page 67

You are looking through glass .
Solution
Remove the glass or change the viewing position to avoid it .
The point of impact shifts after ring rounds
Possible cause
The attachment is configured so that after fitting onto an optical riflescope that had
been properly zeroed , no adjustment of the aiming point is required .
Solution
Yet if point of impact change is observed after putting on the attachment , you can fix it
with  display position calibration  procedure ( see  General Settings  section ).
Poor image quality / Reduced detection
distance
Possible cause
These problems may occur during observation in adverse weather conditions ( snow ,
rain , fog , etc .).
Smartphone or tablet cannot be
connected to the device