Pulsar KRYPTON - Page 11

If it continues to show red , the battery is defective . Do not use this battery !
The LED indicator will display the battery charge status :
LED Indicator Battery Charge Status
Battery is empty
Battery is full
Step 3. С onnect the charger to the mains supply
 Attach the microUSB plug of the USB cable 22 to the microUSB connector 21 on
the charger .
 Connect the USB plug on the cable 22 to the power adapter 23 .
 Plug the power adapter 23 into a 100240 V 24 socket .
 When the indicator  is continuously green , the battery is fully charged . Disconnect
the charger from the mains .
Battery installation
 Lower the lever 4 .
 Remove the protective cover of the battery compartment 3 .