NEW IN SOFTWARE VERSION "MASTERPIECE MAIN No.1.7" - 06-02-92 - Continued
Two Security Codes - only the new code will now allow entry to Set User Access Levels.
The new Programmer's Code -
2, 3, 11, 10
is now required to enter Set User Access Levels. It also works for Card / Memory transfers.
The Operator's Code -
12, 6, 7, 1
is the same as before but now ONLY works for Card / Memory transfers.
* * * * * REMOVE THIS SHEET * * * * *
if you don't want the Lighting Operator to be able to change the User Access Levels.
Masterpiece
Software
Upgrades
Paul F. Mardon, Technical Director, 28-10-98
File: MPN.Sam PAGE 4a of 11
To Next Page
Loading...
