Pulsar Merger LRF User Manual

1.
Insert the Battery Pack (11) along the rail into the APS charger (18)
slot as far as it will go. The APS charger is supplied with your device or
purchased separately.
2.
Point A on the battery and point B on the charger should match.
3.
Connect the Micro USB Type-B plug of the USB cable (22) to the port
(19) of the charger (18).
4.
Connect the second plug of the USB cable (22) to the USB port on the
power adapter (23).
5.
Plug the device into a 100-240 V socket.
6.
The LED indicator (20) will display battery charge status.
7.
Wait until the battery is fully charged (LED indication (20): ).
8.
Two batteries* can be charged at the same time: the second slot is
designed for it.
(20) LED Indicator** Battery Charge Status
Battery level is from 0% to
10%. Charger is connected to a
power supply.
Battery level is from 0% to
10%. Charger is not connected
to a power supply.

Pulsar Merger LRF Specifications

General

Waterproof	IPX7
Range Finder	Yes
Range Finder Accuracy	± 1 m
Laser rangefinder wavelength	905 nm
Battery Type	Li-ion
Operating temperature	-20°C to +50°C