Pulsar Merger LRF User Manual

Switching and Changing
the Batteries
Merger LRFdevices are powered by 2 batteries: built-in Battery Pack and
removable Battery Pack APS3.
1.
If there are two batteries in the device at the same time, two battery
icons are displayed in the status bar (1 - built-in battery, 2 - removable
battery). The device battery is displayed in white, inactive – in grey.
2.
When there is no removable battery in the device, only one icon for the
built-in battery displays in white in the status bar.
3.
When both batteries are fully charged, the device is powered by the
removable battery. If there is low removable battery level, the device
will switch to the built-in battery.
4.
Battery charge level is displayed in % above the icon in the status bar
while charging.
5.
It is possible to replace removable battery with device turned on when
it is powered by built-in battery (the device will continue to work
properly).
Attention! When installing a removable battery with a sufficient charge
level, the device will automatically switch to it.

Pulsar Merger LRF Specifications

General

Waterproof	IPX7
Range Finder	Yes
Range Finder Accuracy	± 1 m
Laser rangefinder wavelength	905 nm
Battery Type	Li-ion
Operating temperature	-20°C to +50°C