Single Measurement Mode
1.
Turn on the device, set up image according to section Powering on
and Image Setting.
2.
When briefly pressing the LRF (6)button– the rangefinder mark will
appear on the screen, empty blanks of range values with the unit of
range measurement will appear in the upper right corner of the image,
i.e. the rangefinder module switches into measurement standby mode.
3.
If PiP mode is activated, the aiming reticle disappears upon activation
of the rangefinder and the PiP window remains active.
4.
Point the rangefinding reticle at an object and press the LRF (6)button.
5.
In the top right corner of the display you will see distance in meters (or
yards - depending on settings).
Note: if the rangefinder is idle longer than for 4 seconds, it turns off
automatically.
Scan Mode
1.
To measure distance in scanning mode, hold down the LRF (6) button
for longer than two seconds. Measurement readings will be changing in
real time as you point the binoculars at different objects. A SCAN
message will appear in the upper right corner of the image.
To Next Page
Loading...
Need help?
General
