1.
Connect one end of the USB cable to the USB Type-C (17) connector of
the riflescope, the other one to the port on your computer using a USB
Type-A adapter.
2.
Turn the device on with a short press of the ON/OFF (4) button (device
that has been turned off cannot be detected by your computer).
3.
Your device will be detected by the computer automatically; no drivers
need to be installed.
4.
Two connection modes will appear on the image: Power and Memory
Card (external memory).
5.
Select connection mode with UP (7)/DOWN (8)buttons.
6.
Confirm selection with a short press of the MENU (9) button.
Power
In this mode, when a computer is used as an external power supply, the
icon appears in the status bar. The device will continue operating
and all functions are available.
The Battery pack installed in the device is not being charged!
A battery recharge feasibility depends on your computer's USB port.
Memory Card
In this mode the device is detected by the computer as a flash card.
This mode is designed for work with the files saved in device's memory.
The device's functions are not available in this mode; the device turns
To Next Page
Loading...
Need help?
General
