Pulsar NS 150 User Manual

Wheels - Tube Less Tyre
CAUTION : Tubeless tyres are fitted in this
motorcycle. The walls of the tyres in
contact with the wheel rim should not be
damaged in any way during fitment /
removal of tyre. The tyre side walls in
contact with wheel rim seals air.
Wheel Puncture :
• Visit nearest known tubeless tyre repair
shop to remove puncture.
• Remove puncture by Filler or Plug method
only.
• Do not use patch method to remove
puncture of tubeless tyre.
Tyre Pressure :
Keep appropriate tyre pressure as mentioned
below to increase life of the tyre & for better
fuel consumption.
Note : Ensure tyres fitted comply with local
rules and regulations governing tyres.
Front 25 PSI
Pulsar 150 NS/AS Rear (Solo) 28 PSI
Rear (with Pillion) 32 PSI
Front Wheel
Removing Front Wheel :
• Park vehicle perpendicular to the ground on
level surface
• Remove speed sensor cable from case meter
assembly.
• Loosen front axle nut.
• Remove front wheel assembly from fork.
25

Pulsar NS 150 Specifications

General

Displacement	149.5 cc
Compression Ratio	9.8:1
Fuel System	Carburetor
Cooling System	Air Cooled
Transmission	5-speed
Clutch	Wet Multi-plate
Front Tyre	80/100 - 17
Rear Tyre	100/90 - 17
Length	2012 mm
Height	1060 mm
Seat Height	805 mm
Kerb Weight	144 kg
Engine Type	Single cylinder, 4-stroke, SOHC
Maximum Power	14 PS @ 8500 rpm
Ignition	CDI
Front Suspension	Telescopic
Rear Suspension	Monoshock
Front Brake	Disc 240 mm
Rear Brake	Drum 130 mm
Fuel Tank Capacity	12 L