Pulsar NS 150 User Manual

Periodic Maintenance Information
Drive chain must be cleaned & lubricated as
per periodic maintenance schedule.
Drive Chain (O-ring type)
• ‘O’ rings must always be kept wet for
best performance hence lubricate every
500 Km.
• O-ring chain lubrication can easily be
done by owners using Bajaj ‘Chain Lube
Spray Can’ available with Bajaj dealers,
or equivalent. Ensure that the lubricant
does not damage the rubber 'O' rings.
Method of O-ring Chain Lubrication :
• Park vehicle perpendicular to the ground on level
surface as mentioned in page no. 21 (6.1). Clean
the chain by using lint free cloth (If excessive
mud / slush found approach Bajaj Service Center
for proper cleaning)
• Shake the can vigorously by holding vertically
upright till the noise of steel ball inside heard
uniformly.
• Hold spray can at the back of rear sprocket with
extension tube nose at 5~10 cm.
• Rotate the wheel in reverse direction & spray the
lube on middle portion of the chain up to full
length of the chain.
Drive
Chain
Cleaning
Drive
Chain
Lubrication
28

Pulsar NS 150 Specifications

General

Displacement	149.5 cc
Compression Ratio	9.8:1
Fuel System	Carburetor
Cooling System	Air Cooled
Transmission	5-speed
Clutch	Wet Multi-plate
Front Tyre	80/100 - 17
Rear Tyre	100/90 - 17
Length	2012 mm
Height	1060 mm
Seat Height	805 mm
Kerb Weight	144 kg
Engine Type	Single cylinder, 4-stroke, SOHC
Maximum Power	14 PS @ 8500 rpm
Ignition	CDI
Front Suspension	Telescopic
Rear Suspension	Monoshock
Front Brake	Disc 240 mm
Rear Brake	Drum 130 mm
Fuel Tank Capacity	12 L