8
Step 3
Attach the high-pressure hose to the male fitting on the front of the pressure washer.
Before attaching the high-pressure hose to the male fitting, remove the plastic cap,
which covers fitting before shipping. This plastic cap can be discarded
once removed. Hand tighten to av oid leakage.
Step 4
Attach the two-way connector to pressure washer. Before attaching the connector to the male
fitting, remove the plastic cap, which is inserted onto the male fitting on the pressure washer
before shipping. This plastic cap can be discarded once removed. After both components have
been installed, attach the garden hose with connector screw on the pressure washer. Connect
the garden hose to the waterspout.
1600 PSI Pressure Washer
1600 PSI Pressure Washer
9
OPERATING INSTRUCTIONS
THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY!
DO NOT USE HOT WATER IN THIS PRESSURE WASHER!
Starting Up
After connecting the pressure washer to your cold
water supply, proceed as follows:
-
Make sure that the on/off switch is
in the off position.
- Connect the garden hose with a quick
connect to the inlet fitting.
- Attach the hose to the gun as per
assembly instruction step #1.
- Insert the adjustable spray nozzle
into the gun as per assembly step
#2.
- Connect the high pressure hose to
thehighpressureoutletfittingas
per assembly step #3.
- Open the water supply valve completely.
- Before turning the unit on, press the gun trigger to bleed all the
remaining air out of the pump and hose.
- Start the pressure washer by turning the on/off switch to the
on position and squeeze the trigger.
REMINDER: Motor does not run continuously, only when theThe trigger is squeezed.
WAR
NING – R risk of inj Utheu nit will start spraying
when trigger is squeezed. When turning the unit off after
use, high pressure still exists inside the hose and unit. Point
the gun in a safe direction and discharge the excess
pressure. NEVER direct the high pressure water stream at
people or animals.
y
To Next Page
Loading...
Need help?
General
