41
CLEAN-UP AND STORAGE
Shutting Down the Pressure Washer
WHEN FINISHED USING THE PRESSURE WASHER,FOLLOW THESE
STEPS TO SHUT DOWN THE UNIT:
Ь Turn the pressure washer to the OFF position.
Ь Turn off the water supply.
Ь Before disconnecting high-pressure hose connection, point the gun in a
safe direction and discharge the high-pressure water.
Ь Disconnect high-pressure hose from the pressure washer and gun.
Ь Disconnect garden hose from the pressure washer.
Ь Remove excess water from the
the
pump by tipping the unit on both sides to
drain any remaining water from inlet and outlet fittings.
Ь Remove WThe ater Intake Filter and flush with water to remove dirt or debris.
Return filter on
c
e it is cleaned.
Ь Drain the detergent reservoir and flush with running water.
Ь Wipe away any remaining water on all parts and fittings.
Ь Engage the gun safety lock.
Ь Store the pressure washer, parts, and accessories in an
area with a temperature above 0°C (32°F).
1600 PSI Pressure Washer
51
Winterizing and Long-Term Storage
FOLLOW ALL OF THE ABOVE SHUT-DOWN PROCEDURES,ADDING
THE FOLLOWING STEPS….
Ь
After disconnecting the water supply, and before disconnecting the
the
high-pressure hose, turn the pressure washer on for 2-3 seconds, until any
remaining water in the pump exits. Turn unit off immediately.
CONTINUED USE OF THE PRESSURE WASHER WITHOUT THE
WATER SUPPLY ATTACHED WILL CAUSE SEVERE DAMAGE TO
THE UNIT!
Ь
Always store the pressure washer, parts, and accessories in an area with a
temperature above 0° C (32° F).
WARNING: FAILURE TO COMPLY WITH THESE STORAGE
INSTRUCTIONS WILL RESULT IN DAMAGE TO THE PUMP
ASSEMBLY
.
Maintenance
Ь This pressure washer is supplied with a closed lubrication system, so no
addition of oil is needed.
Ь Check all hoses and accessories for damage prior to use.
Ь Check the water intake filter periodically for deposits. Clean this filter
regularly for maximum performance.
1600 PSI Pressure Washer
To Next Page
Loading...
Need help?
General
