A / B
This section allows you to compare 2 different states of the plug-in, or 2 different presets.
Slots A and B, accessible through these 2 buttons, represent 2 completely independent
states.
For example, when state A is active, you can load a preset and/or make settings from the
interface, then click on button B; then load another preset and/or make other settings;
buttons A and B now allow you to quickly switch between the two states and easily
compare the 2 presets or sets of settings.
It is also possible to copy the state A to B or vice versa using the > or < buttons located
between A and B.
The A, B and Copy buttons
… Button
The button located on the far right of the bar encompasses various options:
• Setting the oversampling. Oversampling allows sound to be processed at a higher
sampling rate within the plug-in, in return for higher latency and CPU consumption.
Oversampling is disabled by default, as all Pulsar products use advanced
technologies that allow in most cases to do without oversampling, with no
compromise on quality.
• Enabling / disabling the help balloons
• Access to the website
• Access to social media
• Access to communication with technical support
• Link to this user manual
Pulsar Smasher – User Manual v1.0 – page 11/16
The ... button
To Next Page
Loading...
Need help?
General