The Input knob
Output
The Output knob adjusts the gain applied after the compression stage. This is not a digital
gain applied at the output of the plug-in, but a model of the compressor output stage:
above a certain level, increasing this potentiometer will induce saturation.
The Output knob
Mix
The Mix knob is used to dose the amount of compressed signal (100%) and unprocessed
original signal (0%). It will be very useful given the aggressive nature of the Smasher:
indeed on many sources where using 100% would be too extreme, it is still possible to use
the Smasher using a small percentage of Mix.
The Mix knob
Pulsar Smasher – User Manual v1.0 – page 13/16
To Next Page
Loading...
Need help?
General