English
English
1514
TO PRESERVE THE QUALITY OF YOUR WATCH
WATER RESISTANCE
l
Non-water resistant
l
Water resistance (5 bar)*
If “WATER RESISTANT 5 BAR”
isinscribedonthecaseback,
your watch is designed and
manufactured to withstand
up to 5 bar and is suitable for swim-
ming,yachtingandtakingashower.
If “WATER RESISTANT 10
BAR”,“WATERRESISTANT15
BAR” or “WATER RESISTANT
20 BAR” is inscribed on the
l
Water resistance (10 bar/15 bar/20 bar)*
case back, your watch is designed and
manufactured to withstand up to 10 bar/15
bar/20barandissuitablefortakingabath,
shallow diving, but not for scuba diving.
We recommend that you wear a PULSAR
Diver’swatchforscubadiving.
If “WATER RESISTANT” is
not inscribed on the case
back, your watch is not water
resistant, and care should be
If “WATER RESISTANT” is
inscribed on the case back,
your watch is designed and
manufactured to withstand
l
Water resistance (3 bar)
up to 3 bar, such as accidental contact
withsplashesofwaterorrain,butitisnot
designedforswimmingordiving.
taken not to get it wet as water may dam-
agethe movement. Ifthe watchbecomes
wet, we suggest that you have it checked
by an AUTHORIZED PULSAR DEALER or
SERVICE CENTER.
* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the
crown is pushed in completely.
Do not operate the crown when the watch is wet or in water. If used in sea water,
rinse the watch in fresh water and dry it completely.
* When taking a shower with the water resistance 5 bar watch, or taking a bath with
the water resistance 10, 15 or 20 bar watch, be sure to observe the following:
• Do not operate the crown when the watch is wet.
• If the watch is left in warm water, a slight time loss or gain may be caused.
This condition, however, will be corrected when the watch returns to normal
temperature.
NOTE:
Pressure in bar is a test pressure and should not be considered as corresponding
to actual diving depth since swimming movement tends to increase the pressure
at a given depth. Care should also be taken on diving into water.
TEMPERATURES
50° C (122° F) may cause battery
Your watch works with
stable accuracy within a
temperature range of 5° C
and 35° C (41° F and 95°
F). Temperatures over
leakage or shorten the battery life.
Do not leave your watch in very low
temperatures below –5° C (+23° F) for
a long time since the cold may cause a
slighttime lossor gain.However, the
above conditions will be corrected
when the watch returns to normal
temperature.
To Next Page
Loading...
Need help?
General
