PulseTech RediPulse Pro-10 - User Manual

The RediPulse Pro-10™ is a revolutionary system designed to charge and maintain up to ten 12-volt lead-acid
batteries at the same time. Its primary function is to preserve new batteries at peak charge levels by keeping the
plates in like-new condition during storage situations. This unit uses our unique ReNew-IT Pulse Technology™
to remove damaging lead-sulfate deposits on the battery plates. By "cleaning" the plates, the Pro-10 helps
batteries provide maximum performance and reliability.
The Pro-10 is ideal for any type of company or facility that sells or stores batteries. It’s also great for refreshing
new batteries that have been sitting in storage too long.
Using the RediPulse Pro-10 is simple. Just follow the easy instructions inside.
• Inspect the RediPulse Pro-10 for visible damage which might have occurred during shipping and delivery.
• Plug the ac adapter into an electrical outlet (110-volt or 220-volt depending on unit). NOTE: This adapter is
specially designed for this unit. DO NOT use any other adapter. If the adapter has to be replaced at some
point in time, contact PulseTech to order another one.
• Connect the separate sets of positive and negative cables to the batteries (one battery per set -- DO NOT
use on batteries connected in series or parallel). Attach the red positive (+) cable to the positive (+) battery
post and the black negative (-) cable to the negative battery post. If an audible alarm sounds, it indicates an
improper connection.
• At this point the LED above each battery cable in use will light as long as the battery has a charge level of at
least 11 volts. Anything below that will not activate the unit. If the LED light does not light, first make sure the
clips are attached to the battery posts correctly. Also, for safety reasons, the Pro-10 has an undervoltage
lockout. If the light still does not light, this means the battery may have a shorted cell or is below an acceptable
level of power. Remove the battery and have it charged or serviced before attaching it again.
• Turn the POWER switch to the ON position.
NOTE: The Pro-10 is capable of restoring recoverable batteries (i.e. no damaged plates or cells) to their
maximum potential, but results will vary per battery. Also, the amount of time it takes to effectively clean the
Operating Instructions
As of 5/13/02
Because of the possibility of personal injury, always use
extreme caution when working with batteries.
WARNING:
PREPARATION FOR SERVICE & OPERATION

Summary

RediPulse Pro-10 Operating Instructions

Safety Warning

Warning advising extreme caution when working with batteries due to the possibility of personal injury.

Preparation and Connection

Steps for inspecting the unit, connecting the AC adapter, and attaching battery cables correctly to individual batteries.

Usage Precautions and Technology

Usage Precautions

Guidelines for using the unit on single batteries and safe handling of terminal attachments and cables.

Pulse Waveform Technology

Explanation of the unique ReNew-IT Pulse Technology waveform and its benefits for battery maintenance.

Additional Safety Information

Reference to a link for a comprehensive list of important safety instructions related to the product.

Contact and Further Information

Information on how to contact PulseTech for more details on the Pro-10 or other battery maintenance products.

PulseTech RediPulse Pro-10 Specifications

General

Brand	PulseTech
Model	RediPulse Pro-10
Category	Battery Charger
Language	English