Pure Humidifier EC-10

Other manuals for Pure Humidifier EC-10

Installation Instructions24 pages

Questions and Answers

J
Jose FordAug 10, 2025
What to do if my Pure Humidifier will not fill?
- D
  Danielle ThomasAug 10, 2025
  If your Pure Humidifier isn't filling, start by checking the water supply to ensure there's adequate water pressure. If pressure is present, inspect the fill valve to see if it's stuck open and check for 24 VAC across the solenoid valve. Also, verify if there is power to the fill valve by checking for 24 VAC across the solenoid valve; if there's no voltage, look for dirt under the valve seat. Finally, make sure the drain valve is closed, and if you're using an auto-drain system, confirm the manual drain lever on the front of the drain valve is closed.
H
Heather McfarlandAug 29, 2025
How to fix a Pure Humidifier that will not heat?
- S
  Stephen LucasAug 29, 2025
  If your Pure Humidifier isn't heating, begin by checking the heater fuse(s) and replace them if they're blown. Next, check the control transformer to ensure it's producing the correct 24 VAC control voltage. Finally, verify that all safety controls, such as the air flow switch and high-limit switch, are completing the safety circuit.
W
William MurrayNov 17, 2025
Why Pure Humidifier will not stop filling or is short cycling?
- D
  Debra MorrowNov 17, 2025
  If your Pure Humidifier is constantly filling or short cycling, several issues could be the cause. It might be due to an over-temp switch issue, suggesting interference or damage in the level control circuit; ensure Tri-probe Sensor wires are separate from power wiring. A faulty humidity sensor could also be the culprit, so verify the voltage to and from it. Additionally, a faulty immersion heater might be the problem; check and verify the heater's voltage and amperage, comparing them to the diagram or nameplate label ratings. Another potential cause is that the probes need cleaning; remove the Tri-Probe Sensor and clean the probe ends. Finally, check the probe wiring, ensuring the grey wire connects to probe #1 (shortest probe), the violet wire to probe #2 (middle probe), and the blue wir...