Puretec SOL-E3 Series - Position the Softener; Installing the Bypass Valve

11
Copyright © Puretec Pty Ltd 2019 SOL-E3 User Guide
Position the Soener on a level surface.
Installing the Bypass (purchased separately)
Environmental conditions
Operating temperature: 0-48°C
Water conditions
Temperature: 0-50°C
Pressure: 140-875 kPa
Uninstall the plastic ttings
by turning the knob counter
clockwise.
Connect the bypass assembly followed
by the plastic ttings. Hand tighten the
knobs, do not overtighten.
Refer to page 18 for bypass operation.
4
5
Installation Procedure