Puretec SOL-E3 Series - Connecting the Softener to Plumbing

12
Installation & Operation Manual Copyright © Puretec Pty Ltd 2019
Connecting the Soener
Connect the soener to main plumbing. Do not solder brass adapters while they are
inserted in the control module.
6
Apply plumbing tape to
the nipple as required.
Connect the pipe work to the
valve, refer to page 9 for
identication.
Installation Procedure
Note: Solder joints must be
done prior to connecting to the
valve ttings. Leave at least 6”
between the tting and solder
joints when soldering pipes.
Failure to do this could cause
heat damage to the ttings.
This should be carried out by a
qualied tradesman.
FOLLOW LOCAL
PLUMBING CODES