Programming
6.1 Plug into an uninterrupted electrical outlet.
Note: the system transformers are not weather resistant and should be
adequately protected. All electrical connections must be connected accordingly to
local codes.
6.2 Proceed to ‘Programming’ section.
9
Connecting the Drain Line
Locate the 300 mm drain tube and attach to the drain connection, refer to page 9 for
identication of the drain port.
Connecting the Overow
7
8
Connect tubing onto the 5/8” overow
tting (tubing not supplied) and run the
line to the drain. Do not connect the
overow into the drain line, as it must
be a direct and separate line to the
drain. Allow an air gap as per the drain
line. Make sure the drain is not higher
than the overow.
Connect extra tube (tubing not supplied)
onto the 5/8” drain line from the valve
to the drain. Ensure the drain line is not
kinked. The line must not travel more
than 2.4 m up from the valve, otherwise
increase the diameter of the drain line.
Connect drain and overow to sewer or
storm water, whatever is approved by
local authority for salty discharge water.
Ensure drain line has an adequate air gap
of 2 times the pipe diameter or 25 mm,
whichever is larger.
DRAIN
DRAIN
Installation Procedure
To Next Page
Loading...
