If the power goes out for less than two hours, the system will
automatically reset itself. If an extended power outage occurs, then time
of day will ash on and o which indicates that time of day should be
reset. The system will remember the rest.
POWER LOSS
REGENERATION MODE
Typically a system is set to regenerate at a time of low water usage. An
example of a time with low water usage is when a household is asleep. If
there is a demand for water when the system is regenerating, untreated
water will be used.
When the system begins to Regenerate, the display will change to include
information about the step of the regeneration process and the time
remaining for that step to be completed.
The system runs through the steps automatically and will reset itself to
provide treated water when the regeneration has been completed.
Step 4: Next Regeneration Time (hour): Set the hour of the day for
regeneration using
or
buttons. AM/PM toggles aer 12. The
default time is 2:00 am. Press NEXT to go to step 5. Press Regen to return
to previous step.
Step 5: Next Regeneration Time (minutes): Set the minutes
of day for regeneration using
or
buttons. The default setting is ‘00’
Press NEXT to exit Installer Displays/Settings.
Press REGEN to return to previous step.
BACKWASH
REGEN
MANUAL REGENERATION
Sometimes there is a need to regenerate the system sooner than when
the system calls for it, usually referred to as a manual regeneration. There
may be a period of heavy water usage because of guests or a heavy
laundry day.
To initiate a manual regeneration at the preset delayed regeneration time,
when the regeneration time option is set to ‘NORMAL’ or ‘NORMAL + on
0’, press and release ‘REGEN’. The words ‘REGEN TODAY’ will ash on the
display to indicate that the system will regenerate at the present delayed
regeneration time. If you pressed the ‘REGEN’ button in error, pressing the
button again will cancel the request.
Note: If the regeneration time option is set to ‘on 0’ there is no set
delayed regeneration time so ‘REGEN TODAY’ will not activate if ‘REGEN’
button is pressed.
To initiate a manual regeneration immediately, press and hold the ‘REGEN’
button for three seconds. The system will begin to regenerate immedi-
ately. The request cannot be cancelled.
Note: For soeners, if brine tank does not contain salt, ll with salt and
wait at least two hours before regenerating.
CAPACITY
REMAINING
GAL
REGEN TODAY will
ash if a regen-
eration is expected
‘Tonight’.
SET
CLOCK
REGEN
NEXT
REGEN
TODAY
Programming - E3
Programming
AM
REGEN
SET TIME
RETURN TO NORMAL MODE
AM
REGEN
SET TIME
4 5
SET
CLOCK
REGEN
NEXT
SET
CLOCK
REGEN
NEXT
To Next Page
Loading...
