PURSUIT PRO9233E User Manual

128-9324
1 of 12
Model PRO9233E
Installation Manual
Factory Keyless Entry Alarm
Upgrade System
PATENTED: www.voxxintl.com/company/patents
Table Of Contents:
Page 1
TM
SERIES
Before You Begin Page 2
Wire Harnesses Quick View Page 3
Mounting Of The Major Components Page 5
14 Pin Accessory Input/Output Harness Wiring Page 5 - 7
2 Pin Door Lock/Unlock Connector & Wiring Page 7
5 Pin Arm/Disarm/Trunk Shunt Inputs Page 7 - 8
2 Pin LED / Valet Connectors Page 9
Programming Alarm Feature Page 9 - 11
Telematic Upgrade Port Information Page 11
Completing Your Installation Page 11
Dome Delay Learning Proceedure Page 11
Adjusting The Shock Sensor Page 11
Wire Dressing Page 11
Circuit Wiring Layout Page 12

PURSUIT PRO9233E Specifications

General

Brand	PURSUIT
Model	PRO9233E
Category	Remote Starter
Language	English

Summary

Installation of Major Components

Wiring the System

14 Pin Main Wiring Harness Connector

Connects to the control module, powering it and the parking light relay.

White Wire: Parking Light Output

Connects to the positive side of vehicle parking lights for flashing.

Red/White Wire: Module Power

Provides +12 Volt power to the main control module.

Yellow Wire: Ignition Source

Connect to a +12V source active during ignition on and crank positions.

Black Wire: Chassis Ground

Connect to a clean, solid, unpainted metal part of the vehicle's chassis.

Orange Wire: Ground Output When Armed

Connect to starter cut relay control, avoid ignition wire interruption.

Wiring Arm/Disarm Inputs

5 Pin White Connector: Arm/Disarm/Trunk Shunt Inputs

Connects polarity learning inputs for arm/disarm functions.

Arm/Disarm Inputs for Stand Alone Passive System

Programming and Adjustment

Programming Alarm Features

Selectable Features Overview

Adjusting the Shock Sensor