PURSUIT PRO9233Z - Wire Harness Colors and Functions; Input; Output Connector

PRO9233Z_RevA_08/20
2
Detailed Descripons: Wire Harness Colors and Funcons
Input / Output Connector (14-pin connector) See page 19 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
1 2 3 4 5 6 7 8 9 10 11 13 1412
7. GREEN/WHITE – Dome Light Output (-)
The GREEN/WHITE wire supplies Ground (-) when Unlock is acvated from the Remote Control. This output will
automacally turn o aer 30 seconds.
1. WHITE/RED – Parking Light Relay Input (Internal Relay Pin 87)
The WHITE/RED connects to vehicle 12-Volt (+) or Ground (-) to supply the relay output (WHITE wire).
Vericaon for default seng:
• If the vehicle parking light wire registers 12-Volt (+) when the parking lights are on, connect the WHITE/RED wire to a
constant 12-Volt (+) vehicle wire.
• If the vehicle parking light wire registers Ground (-) when the parking lights are on, connect the WHITE/RED wire to a
reliable vehicle ground source.
2. WHITE – Parking Light Relay Output (Internal Relay Pin 30)
At its default seng, the WHITE wire supplies 12-Volt (+) or Ground (-) to the vehicle's parking light wire based on the
connecon of the relay input (WHITE/RED wire).
Vericaon: The vehicle parking light wire registers 12-Volt (+) or Ground (-) when the parking lights are turned on.
6. YELLOW – Ignion Input (+)
The YELLOW wire connects to the vehicle's primary ignion wire. This wire will be used for system programming and
override.
Vericaon: This ignion wire registers 12-Volt (+) when the key is in the accessory, ignion, and start posions.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
4. WHITE/BLACK – Siren Output (+)
The WHITE/BLACK wire supplies 12-Volt (+) to power the siren. Aer mounng the siren, connect the BLACK wire to a
reliable ground source, and connect the WHITE/BLACK wire to the siren’s RED wire.
3. RED – 12-Volt Input (+)
The RED wire connects to the vehicle’s primary 12-Volt (+) wire to power the system.
Vericaon: The power wire registers 12-Volt (+) at all mes.
Note: Before making this connecon, remove all module fuses unl the system is completely connected.
5. PURPLE – Door Trigger Input (+)
The PURPLE wire connects to the vehicle's door trigger wire. This wire will detect a 12-Volt (+) input.
Vericaon: The vehicle door trigger wire registers 12-Volt (+) when a door is opened and opposite when closed.
Note: If the door trigger registers as Ground (-) when a door is opened, use the BROWN, Pin 8, input.