LIMITED 2 YEAR WARRANTY
Putco guarantees it’s Stainless Steel and Aluminum products against defects in workmanship and material for as long as you own
your vehicle. All painted products have a 90 day warranty on the painted surface. Any defects resulting from faulty material or
workmanship will be warranted by Putco and repaired or replaced at our discretion. Putco assumes no extra labor costs. Damages
caused by freight carriers, improper installation, misuse, collision, or neglect will not be warranted by Putco.
07/08/2015 JLS 4RINST-F150
Fog Lamp Assembly
1.
Remove Putco fog lamps from packaging. Check to see if all parts from Table 1.0 are included.
2.
Install Stainless Steel bracket on both fog lamps using the 4 - 10-32 X 3/8" screws and Lock washers
provided (2 per lamp). Refer to Figure 3 for placement.
3.
Transfer Plastic insert from original Fog Lamps onto new Putco fog lamps. Ensure that the Flat side of the
insert is facing towards the wiring harness side of the bracket. In some cases, factory fog lights will have a
left and right side. Make sure to install spacer washer and the plastic insert into the correct tab on the Putco
fog lamp as shown in Figure 4.
Figure 3
Figure 4
To Next Page
Loading...
