Pyle PDA 4800 User Manual

+ RIGHT - + LEFT -
+ BRIDGED -
REMOTEREMOTE
0dB 12dB
REMOTE
CONTROL
BASS
BOOST
FREQ
ADJUST
INPUT
LEVEL
MODE
SELECT
X-OVER
SELECT
POWER
PROTECT
• •
0dB 12dB
• • • •
50Hz 250Hz 5V 0.2V
LP FULL HP STEREO MONO
INPUT OUTPUT
R
L
R
L
CONTROL PANEL
One 2 Channel Amplifier in Mono/Subwoofer Mode
X-OVER SELECT
• In 1 Channel/Mono-Mode select the Lowpass-Position (LP), which eliminates the higher frequencies. The recommended
crossover frequency ranges between 60 - 100Hz, depending on the size and response of the Subwoofer. The Lowpass
adjustment can be done with the FREQ - ADJUST control.
INPUT LEVEL
• Turn the INPUT LEVEL control on the amplifier to 5V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL control clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.
BASS BOOST
• The BASS BOOST - Control increases the bass level at 45 Hz max. +12dB.
Caution! Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.
MODE SELECT
• The MODE SELECT - switch must be in “MONO” - position.
2 Channel Amplifier - Applications
PDA 3000/PDA 6000
Subwoofer 4 - 8 Ohms
Interconnect cable checklist:
• Connect the INPUT of the amplifier to the head unit line output with good quality RCA to
RCA cables.
• Connect the speakers with the terminal block (SPEAKER OUTPUT/ + BRIDGED - ) of the
amplifier.
•The minimum final speaker impedance must not be below 4 Ohms. Too low speaker loads
result in too high heat dissipation and may cause the amplifier run into protection.
• If you use more than one speaker (subwoofer), make sure that both are connected in
phase. Incorrect polarity of the speakers results in total loss of bass response.
Connect RCA cable from
head-unit with RCA input
(INPUT).
Caution
Be careful not to connect speaker (-) to the ground or vehicle chassis.
Connect cable from REMOTE
CONTROL with the input jack
from the amplifier (only PDA
6000).
23

Pyle PDA 4800 Specifications

General

Brand	Pyle
Model	PDA 4800
Category	Car Amplifier
Language	English