14. Before placing, installing, rigging, or suspending any product, inspect all
hardware, suspension, cabinets, transducers, brackets and associated equipment
for damage. Any missing, corroded, deformed, or non-load rated component
could signicantly reduce the strength of the installation, placement or array.
Any such condition severely reduces the safety of the installation and should be
immediately corrected. Use only hardware which is rated for the loading
conditions of the installation and any possible short-term, unexpected
overloading. Never exceed the rating of the hardware or equipment.
15. Consult a licensed, professional engineer regarding physical equipment
installation. Ensure that all local, state and national Regulations regarding the
safety and operation of equipment are understood and adhered to.
16. Refer all servicing to qualied service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or
has been dropped.
Introduction
To get the most from our PDA9HBU, it is recommended that you review all of the
information provided in the instruction manual before operating the equipment.
ATTENTION
1. A: Connect the audio input with the CD/DVD/TV
audio output.
NOTES:
• PDA9HBU does not support video signal, so make
sure that the CD/DVD/TV AUDIO OUTPUT terminal
are connected.
• Noise will be heard when you connect the unit with
CD/DVD/TV video output by mistake.
2. B: Signal output that can be connected with other
amplier or powered speakers
www.PyleUSA.com
3
Input selector will not work if the
signal comes from the Line output.
A
B
To Next Page
Loading...
Need help?
General
