www.PyleUSA.com
6
Technical Parameters:
Environment Temperature: -40c- + 80c
Atmospheric Pressure: 86-106KPa
Relative Humidity: 10% -95%
Environmental Noise: ≤60dB (a)
(A)Alarm Sound Level: ≥30dB(A)
Working Voltage: 9V ~ 16Vdc (12Vdc / 400mA)
Product Size: 73*68*46(cm)
Product Weight: 50g
Troubleshooting
1. No Power and Display on Screen
Start the car engine; check if the cable line is tight; or connect the USB to the
computer to check
2. Inaccurate Time
When the device searched the satellite successfully (The default is New York
time), set it to your local time then save and exit.
3. Inaccurate Speed
When the product is powered ON, press and hold IN button to enter into menu
option, and right push once switched to setting, then short press in the button
to the menu, and right push the button switch to the speed adjust option.
(If the dashboard shows 100, and the device shows the 101, change the default
value at 106%)
4. Over Speed Alarm
Default alarm is 150MPH, please refer to setting to change the value.
5. The Device cannot Auto Power OFF
After vehicle turns o, the device still displays the speed, switch the setting to
Speed Oset and adjust the value same as the device speed. (If the device
shows 5mph after the vehicle turns o, then change the speed oset at 5mph)
6. Wrong Operation Leads to Crash
Reset to factory setting.
To Next Page
Loading...
Need help?
General
